HB<>HPI PRO 5 Car Kit Review

Today show to build HB PRO5 Car Kit.

Box's image

In-side box view

Carbon parts !

and other 2 pack's

Manual & Warranty card.

First, Put on a glue to carbon parts

make sure more strong of when you

damage a car more safety.

No.1 Bulkhead's

※Important

Right 3x4 screw is only one in kit.

It's for under the center motor mount screw.

Battery stopper.

After make center shaft with belt parts,

put this parts !

No.2 Diff parts.

Put on bearing oil every Bearing parts.

Diff case and spool parts.

I do next race is blinky stock class,

change a more smaller spur gear :)

(Kit include 64P 116T)

You must be find

3x5 screws , 3x6 screws

3x5 screw for spur gear mounting.

Done !

Front pully at put on the spool

Must be use thread lock to screw!

It's bearing holder's

Rear diff parts.

Cut a remaining plastic parts of the

Every gears.

Don't forget this shim's !

Kit include 7000# oil.

But you should be change a

3~5000# oil works better !

I show diff positions

you can select different 5 positions

more higher or lower.

Complete B parts!

No.3 upper bulkhead parts.

Front upper bulkhead parts.

Screw & shim's

don't be confuse !

C parts complete.

No.4 suspension parts.

Some kit's little tight to suspension ball's

Please exchanged at where to buy.

D parts complete.

No.5 hub's and drive shaft.

Put on black grease every movement.

Include Carbon and plastic

hub and steering link.

normally use carbon + ALU steering link.

If you have too much high traction conditions,

will need plastic hubs & steering link. :)  

Slowly locking to screw.

Ready to hubs !

※Don't do maximum locking here.

E part complete.

No.6 turnbuckles.

No tips.

Just hard work.. :(

Anti roll bars.

Roll bar must be make moving free.

F part complete.

No.7 Shocks

But after the H parts first make.

No.8 Body mount, Servo mount

Follow the manual !

Follow the manual !

Servo mount

With Xpert :)

Follow the manual also this parts.

Check to the all about screw's

do tightly works.

Put in a electro parts to chassis.

and make a shock !

I use 0.2mm shim at piston.

make a do not play piston at shaft.

Normal is 2 O-ring system.

ball end parts.

Complete PRO 5 building !

How do think about E.C Kim's

1.Plastic parts is really high quality.

Don't need a additional processing.

2. Car feeling is in to the turn smoothly.

exit corner forward traction is quick response !

Check this video

It's first run of my PRO-5 on outdoor track.

Thanks for watch this review.

Your Model Partner 

OKHOBBIES.COM